Page 1 of 1

Need help with Yuffie Kisaragi's weapon

Posted: Wed Aug 29, 2007 6:48 pm
by Deanie425
I am very new to cosplay...I have only done it like 2 times.

I am going to cosplay as Yuffie Kisaragi from FFVII:AC.

Anyways I need help with making her weapon. Both my grandfather and uncle are carpenters so I don't think I will have a problem when it comes to skills...

I just need somewhere to start from.

Any help would be lovely.

Thanks

Posted: Sat Sep 13, 2008 6:47 pm
by Morbid_Circuit
Well, if you layer wood, sand it, then paint over it, you shouldn't have a problem. Or if you want something lighter, craft foam works too! Just make sure you have good silver paint, and maybe a bit of brown to look like rust. Spray paint is best.

Posted: Sat Sep 13, 2008 9:32 pm
by Sterling
This is my best advise; Get a 3inch hole saw drill peice and cut out some wood. Use another hole saw, or hole drill of 1inch in the center. Get 4 1x1 planks and go nuts on a planer and router. get some "DOWEL SCREWS" and connect.