Need help with Yuffie Kisaragi's weapon

Need help with sewing techniques, or making a 10 ft sword? Seek help from other cosplayers here!
Posts: 11
Joined: Wed Nov 01, 2006 5:50 pm
Location: Wyoming, USA

Need help with Yuffie Kisaragi's weapon

Postby Deanie425 » Wed Aug 29, 2007 6:48 pm

I am very new to cosplay...I have only done it like 2 times.

I am going to cosplay as Yuffie Kisaragi from FFVII:AC.

Anyways I need help with making her weapon. Both my grandfather and uncle are carpenters so I don't think I will have a problem when it comes to skills...

I just need somewhere to start from.

Any help would be lovely.

Moto Pinky:st!

Posts: 19
Joined: Sat Sep 13, 2008 1:18 am

Postby Morbid_Circuit » Sat Sep 13, 2008 6:47 pm

Well, if you layer wood, sand it, then paint over it, you shouldn't have a problem. Or if you want something lighter, craft foam works too! Just make sure you have good silver paint, and maybe a bit of brown to look like rust. Spray paint is best.

User avatar
Posts: 1113
Joined: Sat May 29, 2004 4:56 pm
Location: North East, Ohio

Postby Sterling » Sat Sep 13, 2008 9:32 pm

This is my best advise; Get a 3inch hole saw drill peice and cut out some wood. Use another hole saw, or hole drill of 1inch in the center. Get 4 1x1 planks and go nuts on a planer and router. get some "DOWEL SCREWS" and connect.

Return to “Costume / Prop Construction Help”

Who is online

Users browsing this forum: No registered users and 1 guest