Kaneki Kens Kagune from Tokyo Ghoul

Need help with sewing techniques, or making a 10 ft sword? Seek help from other cosplayers here!
Post Reply
Adambart84
Posts: 1
Joined: Fri May 12, 2017 9:13 am

Kaneki Kens Kagune from Tokyo Ghoul

Post by Adambart84 » Fri May 12, 2017 9:25 am

Hi, have been reading through the forums and there is some excellent advice about however I am about to start making Kaneki kens kagune from Tokyo Ghoul, I have a harness from something else which I can attach them to but was wondering what you guys would suggest for the actual limbs. I am planning to make 4 seperate limbs filled with stuffing and with a wire surround in the lining which will attach to the harness.

My main question is what type or 'gauge' of wire should I use? Many people have said 9 gauge steel, would this not be a little heavy? Also any other suggestions would be greatly appreciated.

Thanks for reading!

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest